Here is a side profile of the t-molding as installed:
And here is what the finished edge looks like:
It looks nice! More later.
Tuesday, June 9, 2009
Recreating The Control Panel: Part 6
The next thing I did was route the slot for the t-molding. There is no magic here - I just used my router and 1/16" slot cutting bit. It slot is actually a little small but the t-molding fit in there nice and tight.
Here is a side profile of the t-molding as installed:
And here is what the finished edge looks like:
It looks nice! More later.
Here is a side profile of the t-molding as installed:
And here is what the finished edge looks like:It looks nice! More later.
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment